TANDBERG VCS Administration Manual page 152

Command Reference - xCommand Text goes here
xCommand Description
LinkAdd Adds and configures a new link.
LinkDelete Deletes a link.
Locate Runs the VCS's location algorithm to locate the endpoint
identified by the given alias, searching locally, on neighbors,
and on systems discovered through the DNS system, within
the specified number of "hops". Results are reported back
through the xFeedback mechanism, which must therefore
be activated before issuing this command (e.g. xFeedback
register event/locate).
OptionKeyAdd Adds a new option key to the VCS.
OptionKeyDelete Deletes a software option key from the VCS.
Getting System
Introduction
Started Overview
D 14049.01
07.2007
Parameters
LinkName(r): <S: , 50>
Assigns a name to this link.
Node: <S: , 50>
Specifies the first zone or subzone to which this link will be applied.
Node: <S: , 50>
Specifies the second zone or subzone to which this link will be applied.
Pipe: <S: , 50>
Specifies the first pipe to be associated with this link.
Pipe: <S: , 50>
Specifies the second pipe to be associated with this link.
LinkId(r): <..600>
The index of the link to be deleted.
Alias(r): <S: , 60>
The alias associated with the endpoint you wish to locate.
HopCount(r): <0..55>
The hop count to be used in the search.
Protocol(r): <H33/SIP>
The protocol used to initiate the search.
Key(r): <S: 0, 90>
Specifies the key of the software option to be added.
OptionKeyId(r): <..64>
Specifies the ID of the software option to be deleted.
System H.323 & SIP Registration
Configuration Configuration Control
Zones and Call
Neighbors Processing
5
TANDBERG TANDBERG TANDBERG VIDEO COMMUNICATION SERVER VIDEO COMMUNICATION SERVER VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE ADMINISTRATOR GUIDE ADMINISTRATOR GUIDE
Firewall Bandwidth
Maintenance
Traversal Control
Appendices Appendices Appendices