Getting Started 3; What's In The Box; Connecting The Cables; Installation Site Preparations - TANDBERG VCS Administration Manual

Getting Started

What's in the Box?

To avoid damage to the unit during transportation, the
TANDBERG VCS is delivered in a special shipping box, which
should contain the following components:
•
TANDBERG VCS
•
CD containing VCS Administrator Guide and other
documentation
•
Installation Sheet
•
Registration card
•
Rack-ears and screws
•
Cables:
•
power cables
•
ethernet cable
•
shielded serial cable
Please report any discrepancies to your TANDBERG
representative immediately.
A brief yet detailed description of the procedure to get
you up and going can be found in the Installation
Sheet accompanying your TANDBERG product.
Shielded serial cable
To control the VCS using a
direct connection to a PC,
connect the serial cable
between the VCS's DATA port
and the COM port on a PC.
Getting Getting System
Introduction
Started Started Overview
D 14049.01
07.2007

Installation Site Preparations

•
Make sure that the VCS is accessible and that all cables can
be easily connected.
•
For ventilation: leave a space of at least 10cm (4 inches)
behind the VCS's rear panel and 10cm (4 inches) in front of
the front panel.
•
The room in which you install the VCS should have an
ambient temperature between 0ºC and 35ºC (32ºF and
95ºF) and between 10% and 90% non-condensing relative
humidity.
•
Do not place heavy objects directly on top of the VCS.
•
Do not place hot objects directly on top, or directly beneath
the VCS.
•
Use a grounded AC power outlet for the VCS.

Connecting the Cables

Ethernet cable
To use the VCS over IP,
connect the ethernet cable
from the
VCS to your network. The
LAN2 ,
are not used and should be
left open.
System H.323 & SIP Registration
Configuration Configuration Control
.
LAN1 port on the
Soft power button
3 and 4 connectors
Zones and Call
Neighbors Processing
3 3
TANDBERG TANDBERG VIDEO COMMUNICATION SERVER VIDEO COMMUNICATION SERVER

General Installation Precautions

•
The socket outlet shall be installed near to the equipment
and shall be easily accessible.
•
Never install cables without first switching the power OFF.
Power switch
Power cable
Connect the system power
cable to an electrical
distribution socket.
Firewall Bandwidth
Maintenance
Traversal Control
ADMINISTRATOR GUIDE ADMINISTRATOR GUIDE
Appendices