Enabling The Use Of Administrator Policy - TANDBERG VCS Administration Manual

Administrator Policy
To enable Administrator Policy:
•
VCS Configuration > Policy > Administrator.
You will be taken to the Administrator
Policy page.
•
xConfiguration Policy
AdministratorPolicy Mode
Once you have enabled the use of
Administrator Policy, you must define
the policy to be used. This is done
either via the web interface or by uploading a
CPL script.
If Administrator Policy is on but a policy has
not been configured, then a default policy will
be applied that allows all calls, regardless of
source or destination.
Getting System
Introduction
Started Overview
D 14049.01
07.2007

Enabling the use of Administrator Policy

System H.323 & SIP Registration
Configuration Configuration Control
Zones and Call Call
Neighbors Processing Processing
64
TANDBERG TANDBERG VIDEO COMMUNICATION SERVER VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE ADMINISTRATOR GUIDE
Administrator Policy Mode
On
: Administrator Policy is enabled. If a CPL
script has been uploaded, this policy will be
used. Otherwise, the policy configured via the
Administrator Policy section will be used.
Off : Administrator Policy is not in use.
Save
You must click here for any changes to the
Administrator Policy Mode
Firewall Bandwidth
Maintenance
Traversal Control
to take effect.
Appendices