Configuring The Vcs As A Traversal Server; Overview; Adding A New Traversal Server Zone - TANDBERG VCS Administration Manual

Firewall Traversal

Overview

The VCS has an optional Border Controller
feature. Once this has been enabled, you will
be able to:
•
Allow your VCS to act as a traversal
server for other VCSs and TANDBERG
Gatekeepers. You do this by adding a new
traversal server zone on the VCS, and
configuring it with details of the traversal
client.
•
Provide firewall traversal for any TANDBERG
MXP endpoints registered directly with it.
You can configure the protocols and ports
that will be used.
•
Enable and configure STUN services.
•
Configure the ports used specifically for
firewall traversal services.
The following sections describe how to
configure each of the above options.
Getting System
Introduction
Started Overview
D 14049.01
07.2007

Configuring the VCS as a Traversal Server

Adding a New Traversal Server Zone

•
VCS Configuration > Zones.
You will be taken to the Zones page.
Select New.
You will be taken to the Create Zone page.
•
xCommand ZoneAdd
Name
Enter the name you wish to give to this zone.
The name acts as a unique identifier, allowing
you to distinguish between zones.
Type
From the Type drop-down menu, select
TraversalServer.
Create Zone
Click here to create the zone. You will be
taken directly to the Edit Zone page, where
you can configure the traversal server zone as
required.
System H.323 & SIP Registration
Configuration Configuration Control
Zones and Call
Neighbors Processing
03 03
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Firewall Firewall Bandwidth
Maintenance
Traversal Traversal Control
Appendices