Table of Contents
Advertisement
System Configuration
text
Configuring System Settings
To configure the VCS's system administration
settings:
•
System Configuration >
System.
You will be taken to the
System
Administration
page.
•
xConfiguration SystemUnit Name
•
xConfiguration Administration
About the System Name
The system name is used to identify the VCS,
for example in TMS.
It appears in various places in the web
interface, and in the display on the front panel
of the unit, so that you can identify it when it
is in a rack with other boxes. If no name is
specified, these fields/display will be blank.
We recommend that you give the VCS a name
that allows you to easily and uniquely identify
it.
About Admin Access settings
While it is possible to administer the
TANDBERG VCS via a PC connected directly
to the unit via a serial cable, you may wish to
access the system remotely over IP.
You can do this using either or both:
•
the
web interface
via HTTPS
•
a
command line interface
via SSH or
Telnet.
By default, access via HTTPS and SSH is
enabled; access via Telnet is disabled.
You can also enable access via HTTP.
However, this mode works by redirecting HTTP
calls to the HTTPS port, so HTTPS must also
be enabled for access via HTTP to function.
Getting
System
Introduction
Started
Overview
D 14049.01
07.2007
System Administration Configuration
Save
Click here to save your changes.
You must save your changes and
restart the system for changes to take
effect.
System
System
H.323 & SIP
Registration
Configuration
Configuration
Configuration
Control
Restart
Click here to restart the system.
TMS accesses the VCS via the web
server. If HTTPS mode is turned off,
TMS will not be able to access it.
Zones and
Call
Neighbors
Processing
9
TANDBERG
VIDEO COMMUNICATION SERVER
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
ADMINISTRATOR GUIDE
System name
Defines the name of the VCS. Choose a name
that uniquely identifies the system.
Session time out (minutes)
Sets the number of minutes that an
administration session (HTTPS, Telnet or SSH)
may be inactive before the session is timed
out. A value of 0 turns session time outs off.
Telnet service
Determines whether the VCS can be accessed
via Telnet.
SSH service
Determines whether the VCS can be accessed
via SSH and SCP.
HTTP service
Determines whether HTTP calls will be
redirected to the HTTPS port.
HTTPS service
Determines whether the VCS can be accessed
via the web server. This must be On to enable
both web interface and TMS access.
By default, access via HTTPS and SSH
!
is enabled; access via Telnet is
disabled. To securely manage the VCS
you should disable Telnet, using the encrypted
HTTPS and SSH protocols instead. For further
security, disable HTTPS and SSH as well and
use the serial port to manage the system.
Firewall
Bandwidth
Maintenance
Traversal
Control
Appendices
Advertisement
Table of Contents
