Configuring A Traversal Client Zone - TANDBERG VCS Administration Manual

Firewall Traversal

Configuring a Traversal Client Zone

•
VCS Configuration > Zones.
You will be taken to the Zones page.
Click on the name of the zone you wish to
configure.
You will be taken to the Edit Zone page.
•
xConfiguration Zones Zone
Getting System
Introduction
Started Overview
D 14049.01
07.2007
Configuring the VCS as a Traversal Client
Retry interval
Specifies the interval in seconds with which a
failed attempt to establish a connection to the
traversal server should be retried.
H.323 mode
Determines whether H.323 calls will be
allowed to and from this zone.
H.323 protocol
Determines which of the two firewall traversal
protocols to use for calls to the traversal
server.
H.323 port
Specifies the port on the traversal server to
be used for H.323 firewall traversal calls.
SIP mode
Determines whether SIP calls will be allowed
to and from this zone.
SIP port
Specifies the port on the traversal server to
be used for SIP calls from this VCS
SIP transport
Determines which transport type will be used
for SIP calls to and from the traversal server.
Save
Remember to your changes.
System H.323 & SIP Registration
Configuration Configuration Control
Primary address
Specifies the IP address or FQDN of the
traversal server.
Zones and Call
Neighbors Processing
0 0
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Alternate 1 - Alternate 5 Address
Specifies the IP addresses or FQDNs of any
alternates configured on the traversal server.
Firewall Firewall Bandwidth
Maintenance
Traversal Traversal Control
Appendices