Configuring The Vcs As A Traversal Client; Overview; Adding A New Traversal Client Zone; D14049.04 - TANDBERG VCS Administrator's Manual

Grey Headline (continued)

Configuring the VCS as a Traversal Client

Overview

To enable your VCS to act as a traversal
client on behalf of its endpoints and neighbor
gatekeepers, you must create a connection
between it and a traversal server (e.g.
a TANDBERG VCS Expressway or Border
Controller).
You do this by adding a new traversal client
zone on the VCS client and configuring it with
the details of the traversal server.
Overview and
Introduction Getting Started
Status

D14049.04

JULY 2008
•
VCS Configuration > Zones .
You will be taken to the Zones page.
Select New.
You will be taken to the Create Zone page.
•
xCommand ZoneAd d
Name
Enter the name you wish to give to this zone.
The name acts as a unique identifier, allowing
you to distinguish between zones of the same
type.
Type
From the Type drop-down menu, select
TraversalClient.
Create Zone
Click here to create the zone. You will be taken
directly to the Edit Zone page, where you can
configure the traversal client zone as required.
You can create more than one traversal
client zone if you wish to connect to
multiple traversal servers.
System VCS Zones and
Configuration Configuration Neighbors

Adding a New Traversal Client Zone

Call Bandwidth
Processing Control
156
TANDBERG VIDEO COMMUNICATIONS SERVER
Firewall
Applications Maintenance
Traversal
ADMINISTRATOR GUIDE
Appendices