TANDBERG VCS Administration Manual page 154

Command Reference - xCommand Text goes here
xCommand Description
SubZoneAdd Adds and configures a new subzone.
SubZoneDelete Deletes a subzone.
Getting System
Introduction
Started Overview
D 14049.01
07.2007
Parameters
SubZoneName(r): <S: , 50>
Assigns a name to this subzone.
Address: <S: 0, 39>
Specifies an IP address used (in conjunction with the IP Prefix Length) to identify a subnet to be assigned to this subzone.
PrefixLength: <0..128>
Specifies the number of bits of the Subnet IP address which must match for an IP address to belong in this subzone.
TotalMode: <None/Limited/Unlimited>
Determines whether this subzone has a limit on the total bandwidth of calls being used by its endpoints at any one time.
Total: <..00000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if Mode is set to Limited).
PerCallInterMode: <None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone.
PerCallInter: <..00000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if Mode is set
to Limited).
PerCallIntraMode: <None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone.
PerCallIntra: <..00000000>
Specifies the bandwidth limit (in kbps) on any one call between two endpoints within this subzone.
SubZoneId(r): <..00>
The index of the subzone to be deleted.
System H.323 & SIP Registration
Configuration Configuration Control
Zones and Call
Neighbors Processing
54
TANDBERG TANDBERG TANDBERG VIDEO COMMUNICATION SERVER VIDEO COMMUNICATION SERVER VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE ADMINISTRATOR GUIDE ADMINISTRATOR GUIDE
Firewall Bandwidth
Maintenance
Traversal Control
Appendices Appendices Appendices