Dns Configuration; Configuring Dns Settings; About Dns Servers; About The Dns Domain Name - TANDBERG VCS Administration Manual

System Configuration text

Configuring DNS Settings

To configure the VCS's DNS settings:
•
System Configuration > DNS.
You will be taken to the DNS page.
•
xConfiguration IP DNS

About DNS Servers

In order to use URI dialing or ENUM dialing,
you must specify a DNS server to be queried
for address resolution. You can specify up to
5 DNS servers. Normally only the first DNS
server will be queried, but if it fails to respond,
all DNS servers will be queried.

About the DNS Domain Name

The DNS Domain Name is used when
attempting to resolve server addresses
configured on the VCS that are not fully
qualified. It applies only to the following:
•
LDAP server
•
NTP server
•
External Manager server.
The DNS Domain Name is appended to the
server address before a query to the DNS
server is executed. Note however that DNS
will also be queried for the server address as
configured, without the DNS Domain Name
appended. For this reason we recommend
that all server addresses use a FQDN.
The DNS Domain name plays no part in URI
dialing.
Getting System
Introduction
Started Overview
D 14049.01
07.2007

DNS Configuration

System System H.323 & SIP Registration
Configuration Configuration Configuration Control
Zones and Call
Neighbors Processing

TANDBERG VIDEO COMMUNICATION SERVER
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
ADMINISTRATOR GUIDE
Address 1 to Address 5
Sets the IP address of a DNS server to be
queried when resolving domain names.
Domain name
Specifies the name to be appended to the
host name before a query to the DNS server
is executed.
Save
Click here to save your changes.
Firewall Bandwidth
Maintenance
Traversal Control
Appendices