Table of Contents
Advertisement
5.
Push the print head in the direction of the arrow
until you hear a click, confirming that it has been
inserted properly.
6.
Close the print head compartment cover and press
the
key again.
7.
The fax machine automatically performs a self-test
procedure to check the print head. For a few sec-
onds the display shows
INIT. PRINT HEAD
PLEASE WAIT
Once the print head has been installed, the dis-
play will show:
ALIGNMENT
8.
Press the START key.
The machine automatically feeds a sheet of paper
and prints the print head alignment procedure text.
The display shows:
PRINTING
The installation test page will read "Test : Bidirec-
tional Alignment".
If the alignment corresponding to the «xx» value
on the test page represents the best possible
alignment, press the START key. If it does not,
select a different setting using the
then press the START key.
I
NSTALLATION
The display will show:
The machine will print another test page with the val-
ues you have set, which will read "Alignment confir-
mation", and then return to the waiting mode.
The display will show «RX ON FAX 100%» on the
upper line and the date and time on the lower line.
If you have any problems while installing
or aligning the print head ...
If, after installing the print head, the message "CHECK
PRINT HEAD, PRESS RESUME" is displayed again,
try removing and reinserting the print head, pushing it
harder.
(Remember to press the
after installing the print head).
If the message persists, remove the print head and
clean the electrical contacts both on the print head
and the carriage. See "Cleaning the print head's
electrical contacts ..." in the "Maintenance" chapter.
To release the print head, push the lever towards the
back of the print head compartment.
Print head replacement ...
To replace the print head, see the "MAINTENANCE"
chapter.
PRINTING
key both before and
9
Advertisement
Table of Contents
