Advertisement
Wordclock
Wordclock
Wordclock
Wordclock
To configure the Digital 328 as the wordclock master, enter the 328 Menu pages by pressing the
<MENU> button on the right hand side of the LCD display. Using the encoder beneath the
display, scroll up or down until the 'Clock Source Sel' menu is highlighted, and press <ENTER>.
Here, either the internal 44.1kHz clock or the internal 48kHz clock must be selected, depending
on the sampling rate at which work is to be done. Press <ENTER> to set the sample rate and
<MENU> to return to the menu pages.
<Wordclock Src.>
Internal:44.1kHz
To ensure that the Digital 328 Tape Ports are set to ADAT to work with the MOTU 2408 mkII,
enter the 328 Menu pages by pressing the <MENU> button on the right hand side of the LCD
display. Using the encoder beneath the display, scroll up or down until the 'Tape Port Select'
menu is highlighted. Press <ENTER> and keep pressing the Up cursor arrow until the '<Tape
Ch17-24 >' menu page is displayed. Using the encoder set the Bank Source to ADAT. Press the
Down cursor arrow once, to set the wordlength. The MOTU 2408 mkII is capable of 24-bit
recording, and so for optimum results, 24-bit wordlength can be selected here. If your audio
sequencer software does not allow 24-bit recording, 20-bit or 16-bit should be selected. The
sequencer manuals should be consulted for further information. The wordlength is set on the
328 with the encoder. Press <ENTER> to set the wordlength and <MENU> to return to the
menu pages.
<Tape Ch17->24 >
Bank Source:ADAT
<Tape Ch17->24 >
Wordlength:
Digital 328 Setup
Digital 328 Setup
Digital 328 Setup
Digital 328 Setup
or
24
MOTU 2408 mkII Setup Guide
<Wordclock Src.>
Internal:48.0kHz
<Tape Ch25->32 >
Bank Source:ADAT
<Tape Ch25->32 >
Wordlength:
2
24
3
Advertisement
