Silvercrest CRB-532 Instructions Manual page 42

Note:
If the ratio is set to "0", the volume on both speaker groups is the same.
If the control dial is set to the maximum position of "8" on one of the two sides, the speaker group in the opposite side will be
mute. To change this, turn the control dial
The setting is saved either when the desired value is confirmed by pressing the control dial
not change anything on the device for approximately five seconds). If you confirm the selection by pressing the control dial
you then advance to the next possible setting. If you use automatic storage, the device will return to the standard display.
Changing the volume distribution between the front and rear speaker group (FADER)
After pressing the control dial
(FADER) can be adjusted. The message "FAD" will appear on the display along with the set volume ratio between the front and
rear speaker group (e.g. "FAD 2F"). To change the ratio between the speaker groups, turn the control dial
counter-clockwise. Depending on the direction in which the control dial is turned, an "F" or an "R" will appear on the display,
together with a digit (e.g. "2F" or "3R"). These provide information about the direction in which the volume ratio is changed and
also the extent of the change. The ratio between the front and rear speaker group can be set in a range between "8F" and "8R".
The volume ratio between the speakers changes according to the setting. As the volume of one speaker group increases, the
other decreases.
Note:
If the ratio is set to "0", the volume on both speaker groups is the same.
If the control dial for one of the two speaker groups is turned to the maximum setting "8", the other speaker group is muted.
To change this, turn the control dial
The setting is saved either when the desired value is confirmed by pressing the control dial
not change anything on the device for approximately five seconds). If you confirm the selection by pressing the control dial
you advance to the next possible setting. If you use automatic storage, the device will return to the standard display.
Note:
After pressing the control dial
device will automatically return to the initial display.
108
again.
five times, the settings for the speaker distribution between the front and rear speaker group
again.
six times, the volume setting is reached again. If no changes are made for 5 seconds, the
or through automatic storage (do
clockwise or
or through automatic storage (do
,
,