Silvercrest CRB-532 Instructions Manual page 10

4. Now attach the installation frame by bending the installation brackets towards the outside with a screwdriver. The frame is
properly installed when it can no longer be pulled out, yet also keeps from sliding further into the installation slot.
5. Now connect the cable set and the antenna corresponding to Abb. 8.3 and Abb. 8.4 as well as the table below to the
vehicle's electric system. Also observe the specifications in sections 8.2 to 8.4.
Connector pin assignment ISO connector plug (also see Abb. 8.3 number 7)
Contact
Plug A
1
2
3
4 Ignition (ACC+) / red
5 Car antenna / blue
6 Automatic operating panel dimmer / orange
7 Battery 12V (+) / yellow
8 Ground / black
6. Slide the device into the installation frame as far as the stop point. You will hear the device audibly lock into place.
7. Attach the front frame and then insert the operating panel.
76
Plug B
Rear right (+) – purple
Rear right (-) - purple / black
Front right (+) - grey
Front right (-) – grey / black
Front left (+) - white
Front left (-) – white / black
Rear left (+) - green
Rear left (-) – green / black