Selecting A Paper Setting; Automatically Selecting The Paper Size ("Auto" Paper Setting) - Konica Minolta BIZHUB 501 Copy Operations

Basic copy operations
3.5

Selecting a paper setting

The paper size can be selected automatically according to the original size or it can be specified manually.
Specify the paper size according to the corresponding procedure, depending on the desired copy settings.
As the factory default, "Auto" is selected.
Reminder
When copying after selecting a paper tray with letterhead paper selected as the paper type, the copy
speed will be slow, even with single-sided copying, since the paper alignment operation is performed.
Note
If a setting for special paper is selected for a paper tray, that tray is not selected automatically with the
"Auto" Paper setting. Be sure to specify a paper setting when special paper is loaded into a paper tray.
For details, refer to "Specifying a paper type for bypass tray" on page 7-18.
If the "Auto Paper Select" was selected at the "Auto Zoom" setting, the Zoom screen appears. Touch
the button for the desired zoom ratio.
The "Auto" Paper setting cannot be combined with the "Auto" Zoom setting.
For details on specifying the priority of paper trays, refer to "Specifying user settings" on page 12-18.
3.5.1

Automatically selecting the paper size ("Auto" paper setting)

The size of the loaded original is detected, and copies are produced using paper of the same size.
If the "Full Size" Zoom setting was specified, paper of the same size as the original is selected.
If the zoom ratio was increased or decreased, a paper size that corresponds to the specified zoom ratio is
automatically selected.
1
In the Basic screen, touch [Paper].
The Paper screen appears.
bizhub 501/421/361 (Version 2)
3
3-35