Xerox WorkCentre 5020 System Administrator Manual page 45

Workcentre
Hide thumbs Also See for WorkCentre 5020:
Table of Contents

Advertisement

4) If you are using the Port9100 port, select the [Enabled] check box for
[Port9100]. If you are using the LPD port, select the [Enabled] check box for
[LPD].
NOTE: Confirm that the SNMP port is enabled. If not enabled, select the [Enabled]
check box for [SNMP]. For information on how to configure SNMP settings, refer to
SNMP Configuration on page 49
5) Click [Apply].
6) If prompted, enter the System Administrator user ID and passcode, and click
[OK].
NOTE: By default, the System Administrator user ID is "11111" and its passcode is not
set.
NOTE: You can also enable each port on the Control Panel of the machine in the
System Setting Mode. For more information, refer to
4.
Depending on your requirements, configure the LPD or Port9100 settings.
1) Click the [Connectivity] folder, and then [Protocols] folder.
2) Click [LPD] or [Port9100].
3) Configure the required options.
The following table shows the information fields and settings on the [Port 9100] and
[LPD] pages.
Port
LPD
General
Port 9100
General
Port
Information
.
Setting items
Protocol
Physical Connection
Port Number
Connection
Time-Out
Maximum Number of
Sessions
Protocol
Physical Connection
TCP Port Number
Bidirectional
Maximum
Connections per Port
End of Job Timeout
PDL Switching
TCP/IP (LPD or Port9100)
System Settings on page 109
Description
Displays whether the protocol is
enabled or disabled.
Displays "Ethernet".
Enter the port number within the range
of 1 to 65535.
Specify the connection time-out period
when transmission fails.
Enter the maximum number of
sessions.
Displays whether the protocol is
enabled or disabled.
Displays "Ethernet". This is a display-
only item.
Enter the port number for Port 9100.
Displays whether the bidirectional
communication is enabled or disabled.
This is a display-only item.
Displays "8". This is a display-only item.
Specify the connection time-out period
when transmission fails.
Displays whether the PDL Switching
feature is enabled or disabled. This is a
display-only item.
.
45

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workcentre 5020dn

Table of Contents