Xerox WorkCentre 5020 System Administrator Manual page 26

3 Using CentreWare Internet Services
If you have selected [0] (STATIC) in Step 3, proceed to Step 5 to configure the protocol
settings. Otherwise, proceed to Step 8.
5.
Using the numeric keypad, enter the IP address for the machine in the format
"xxx.xxx.xxx.xxx".
The following table shows the system setting menu numbers for specifying the IP
address.
IP Address (xxx.xxx.xxx.xxx)
Menu Number
1) Enter the menu number [103], and then press the <Start> button to confirm the
2) Enter a value for the first block of the IP address, and then press the <Start>
3) Enter the menu number [104], and then press the <Start> button to confirm the
4) Enter a value for the second block of the IP address, and then press the
5) Enter the menu number [105], and then press the <Start> button to confirm the
6) Enter a value for the third block of the IP address, and then press the <Start>
7) Enter the menu number [106], and then press the <Start> button to confirm the
8) Enter a value for the fourth block of the IP address, and then press the <Start>
6.
Using the same method as in Step 5, enter the subnet mask.
The following table shows the system setting menu numbers for specifying the
subnet mask.
Subnet Mask (xxx.xxx.xxx.xxx)
Menu Number
7.
Using the same method as in Step 5, enter the gateway address.
The following table shows the system setting menu numbers for specifying the
gateway address.
Gateway Address (xxx.xxx.xxx.xxx)
Menu Number
NOTE: If you do not wish to set the gateway address, skip this step.
26
entered menu number.
button to confirm the entered value.
entered menu number.
<Start> button to confirm the entered value.
entered menu number.
button to confirm the entered value.
entered menu number.
button to confirm the entered value.
1st block 2nd block
103 104
1st block 2nd block
107 108
1st block 2nd block
111 112
3rd block 4th block
105 106
3rd block 4th block
109 110
3rd block 4th block
113 114