Xerox WorkCentre 5020 System Administrator Manual page 40

5 Machine Status
General Setup
40
Feature
Configuration
Job Management • Job Deletion
Paper Tray
Attributes
Paper Size
Settings
Unit Settings
Power Saver
Settings
Setting items
Displays information such as the memory capacity,
available printer language, and installed software.
• Memory
Displays the size of the installed memory, and
amount of memory used for each port/protocol.
• Available PDL
Lists the printer language used by the machine and
its version.
• Software
Displays the version of software (firmware) installed
on the machine.
Allows you to set whether to allow all users or only
the System Administrator to delete jobs.
• Trays
Lists the paper trays installed.
• Paper Size
Lists the paper size set for each tray.
• Priority
Allows you to set the priority for specified paper
trays.
Allows you to specify the paper size table. You can
select from [A/B Series (8K/16K)], [Inch Series
(8.5 x 13")], [Inch Series (8.5 x 13.4")], and [Inch
Series].
NOTE: Depending on the paper size table the machine
is programmed to use, the document sizes that can be
detected by the Document Feeder change. Refer to
Document Sizes Detectable by the Document Feeder
on page 121
.
Allows you to specify [Inches] or [Millimeters] as the
unit for entering document or scan sizes.
• Low Power Mode Time-Out
Allows you to specify the time-out period before the
machine enters the Low Power Mode from the last
user operation.
• Sleep Mode Time-Out
Allows you to specify the time-out period before the
machine enters the Sleep Mode from the last user
operation.
NOTE: You must specify a longer time period for the
Sleep Mode than for the Low Power Mode.