Configuring a Load Sharing Mode for Load-Sharing Link Aggregation
Groups
Configuring an Aggregation Group
The following ports cannot be assigned to an aggregation group: Stack ports, RRPP-enabled
ports, MAC address authentication-enabled ports, port security-enabled ports, IP source
guard-enabled ports, and 802.1x-enabled ports.
You are recommended not to assign reflector ports of port mirroring to an aggregation group. For
details about reflector ports, refer to Port Mirroring Configuration in the Access Volume.
Configuring a Static Aggregation Group
Follow these steps to configure a Layer 2 static aggregation group:
To do...
Enter system view
Create a Layer 2
aggregate interface and
enter the Layer 2
aggregate interface
view
Exit to system view
Enter Ethernet interface
view
Assign the Ethernet
interface to the
aggregation group
Task
Enabling LinkUp/LinkDown Trap Generation
for an Aggregate Interface
Shutting Down an Aggregate Interface
Use the command...
system-view
interface bridge-aggregation
interface-number
quit
interface interface-type
interface-number
port link-aggregation group number
2-6
Remarks
Optional
Optional
Optional
Remarks
—
Required
When you create a Layer 2
aggregate interface, a Layer 2
static aggregation group
numbered the same is created
automatically.
—
Required
Repeat the two steps to assign
multiple Ethernet interfaces to
the aggregation group.