Replacing The Cutter Unit - Oce 5250 User Manual

Replacing the cutter unit

If the cutter blade wears down, you can replace the cutter unit (casing and
blade). For ordering information, consult the Océ Web site.
You can have a longer use of the cutter by changing the cutting area of the
cutter blade. The cutter unit is designed with 5 different positions that you can
optimize before you replace it.
To change the cutting area of the cutter blade
Turn the black thumbwheel of the cutter unit. The thumbwheel has 5
positions, indicated from 1 to 5.
To replace the cutter unit
Press the printhead key on the printer control panel. The carriage moves out of
1
the purge station.
Open the dust cover.
2
The cutter is located on the left hand side of the carriage, as shown in figure 64
on page 132.
Press on the cutter unit tab, and slide out the cutter assembly.
3
Remove the replacement unit from the packaging and insert in the cutter
4
socket.
[64] Replacing the cutter unit
If you do not put a replacement unit in then an error occurs.
Note:
132 Océ 5250 user manual
[2] [1]