Oce 5250 User Manual page 47

To align the media
Adjust the media so that its right edge flushes with the vertical reference mark
1
[1] (see figure 34).
Raise the green lever [2] to fix the media.
2
Close the dust cover. The displays reads:
3
NO MEDIA
PRESS ENTER TO INSTALL MEDIA
Set the media mode to 'roll' (see chapter , 'Setting the media format' on
4
page 56).
Press 'enter'. The printer detects and loads the media. When the media aligns
5
correctly, the display reads 'ready'.
[34] Fixing the roll media
If the media is not correctly aligned the control panel display reads:
Note:
MEDIA MISALIGNED
REALIGN MEDIA AND PRESS ENTER
Follow the instructions in the previous section, to align the media
Note:
correctly.
Getting started
[2]
[1]
47