This position provides the maximum height (2.4 mm) between the platen
Top
and the head. Set the lever to this position when printing on thick media and
when printing images.
Push the lever to the required position. Make sure that it snaps firmly into
4
place.
Close the dust cover.
5
Printing the registration print
You must make a registration print after each print head installation or
replacement to check for proper position. You can use cut sheet or roll media,
with a minimum A3 media size.
To print the registration print
Check that you have loaded the media, and that the printer is ready to print.
1
Press the 'down' arrow once to enter the menu.
2
Follow the flowchart path to get to 'registration'.
3
Press 'enter' to print.
4
Troubleshooting
Media type
Configuration
Utilities
Calibration
Print
Registration
147