Hp-Rtl Commands - Oce 5250 User Manual

Use the following command to initialize correctly an HP-GL/2 file:
ESC%-1BBPIN;
BPIN;
You can select HP-GL/2 format from the control panel under 'data format'.
You can use a Remote Configuration File (RCF) command to select the
HP-GL/2 format, which is the recommended start-up on HP-GL/2.
The
PG;
Otherwise, the printer gives unpredictable results. The printer may also hang,
if the following file is also HP-GL/2.
Use the following commands to close correctly an HP-GL/2 file:
PUSP0PG;
PUSP0PGRP;

HP-RTL commands

HP-RTL is a subset of HP-GL/2. Hence, all HP-RTL print data files must start
with
ESC%-1BBPIN;
To use HP-RTL, set 'data format' to 'auto' or 'hpgl/2' on the printer control
panel. You can also select HP-GL/2 via a remote configuration file.
HP-RTL print data files must close with
to the HP-GL/2 format. Otherwise, the printer gives unpredictable results. The
printer may also hang.
See 'HP-RTL commands' on page 190 for a list of supported HP-RTL
commands.
Print data formats
..... or,
.....
command is mandatory to close properly the HP-GL/2 file.
or,
(This will print one additional copy of the file.)
or
BPIN;
which reverts the printer
ESC%0B; PG;
111