MINOLTA-QMS 2200 User Manual page 118

Symptom
Printer power
is not on.
110
Cause
The power cord is not
correctly plugged into the
outlet.
The mailbox power cord is
not correctly connected.
The power switch is not
correctly turned on.
Something is wrong with
the outlet you are using for
the printer.
The printer is connected to
an outlet with a voltage or
frequency that does not
match the printer specifica-
tions.
Solution
Turn the power switch to the off (O) position, then
unplug the power cord from the outlet and plug it back
in.
Turn the printer power switch and the mailbox power
switch to the off (O) position, then reconnect the mailbox
power cord using the procedure below:
—Connect the mailbox power cord plug end to the
mailbox power socket (lower connection).
—Connect the mailbox power cord socket end to the
printer power plug.
—Connect the printer power cord socket end to the
mailbox power plug (upper connection).
—Plug the printer power cord plug end into the outlet.
—Turn the mailbox power switch on.
—Turn the printer power switch on.
Set the power switch to the off (O) position, then set it
back to the on (I) position.
Turn the printer power switch and the mailbox power
switch to the off (O) position, then turn on the power
again using the procedure below:
—Turn the mailbox power switch on.
—Turn the printer power switch on.
Plug another electrical appliance into the outlet and see
whether it operates properly.
Use a power source with the following specifications:
— Power
Japan: 100 VAC 50–60 Hz 12 amps
North America: 120 VAC 50–60 Hz 8 amps
Europe: 220-240 VAC 50–60 Hz 6 amps
Latin America: 120 VAC 50–60 Hz 8 amps
220-240 VAC 50–60 Hz 6 amps
— Voltage fluctuation
Japan: 100 VAC ±10%
North America: 120 VAC ±10%
Europe: 220-240 VAC ±10%
Latin America: 120 VAC ±10%
220-240 VAC ±10%
— Frequency fluctuation rate within 50/60 ±3 Hz
Solving Other Problems