MINOLTA-QMS magicolor 2350 User Manual page 138

Symptom
The print or
color density
may be
uneven.
Irregular
print or
mottled
image
appears.
There is
insufficient
fusing or the
image comes
off when
rubbed.
136
Cause
One or more of the
toner cartridges may
be near empty or
damaged.
The OPC drum may
have been installed
improperly or be
defective.
The printer is not on a
level enough surface.
The media is moist
from humidity.
Humidity may be too
high.
Media doesn't meet
printer specifications.
One or more of the
toner cartridges is
defective.
The OPC drum
cartridge is damaged.
The media is moist
from humidity.
Media with
specifications not
covered by the printer
warranty is being
used.
The media type may
be incorrectly set.
Solving Problems with Printing Quality
Solution
Install new toner cartridges. (Quality/
Toner/Replace)
Reinstall the OPC drum cartridge. If
necessary, replace the OPC drum
cartridge and waste toner bottle.
Level the printer (not exceeding ±1°
slant at any point around the machine).
Remove the moist media and replace it
with new, dry media.
Adjust the humidity in the paper
storage area.
Use media that is covered by the
printer warranty. For information about
approved media, go to
www.minolta-qms.com. After selecting
your country, choose Support &
Drivers, select your printer, and then
choose Media Recommendations.
Remove the toner cartridge (Quality/
Toner/Replace) and check for
damage. If necessary, replace it.
Remove the OPC drum cartridge and
check for damage. If necessary,
replace the OPC drum cartridge and
waste toner bottle.
Remove the moist media and replace it
with new, dry media.
For information about approved media,
go to www.minolta-qms.com. After
selecting your country, choose Support
& Drivers, select your printer, and then
choose Media Recommendations.
When printing envelope, glossy stock,
labels, transfer media, transparencies,
and thick stock, the appropriate media
type must be specified in the printer
driver and the printer control panel.