Service Messages - MINOLTA-QMS magicolor 2350 User Manual

Service Messages

A service message sometimes occurs as a result of an unusual combination
of events, not because of an actual problem. When the printer stops and a
service message displays in the message window, turn the printer off and
then back on. This often clears the service message indicator, and printer
operation resumes. Always try this before making a service call.
Service calls should be placed to the vendor from whom you purchased the
printer. If you cannot get service from your vendor, see the Service & Support
Guide or www.minolta-qms.com for additional contact information.
This service
message...
SERVICE CALL 0B
XFER FAN
SERVICE CALL 0C
PWR SUPPLY FAN
SERVICE CALL 0E
SUCTION FAN
SERVICE CALL 1A
FUSER UNIT
SERVICE CALL 1B
FUSER UNIT
SERVICE CALL 2A
MEM MALF DATA
SERVICE CALL 2B
MEM MALF ACCESS
SERVICE CALL 04
ENGINE BOARD
SERVICE CALL 05
FLASH ROM
Status, Error, and Service Messages
means...
The transfer fan is
malfunctioning.
The power supply fan is
malfunctioning.
The suction fan is
malfunctioning.
The fuser unit is having
temperature control
problems.
The printer memory is
malfunctioning.
The engine board
requires service.
The flash ROM is
malfunctioning.
do this...
Contact your vendor
with the error
information. If you
cannot get service from
your vendor, see the
Service & Support
Guide or
www.minolta-qms.com
for support contact
information.
Retry loading engine
firmware; then call
service if necessary.
145