MINOLTA-QMS magicolor 2350 User Manual page 134

Symptom
The printer
pauses.
You cannot
access
PageScope
Light.
You cannot
change the
options in
PageScope
Light.
132
Cause
The printer pauses for
the color calibration
procedure (also
known as the
Auto-Image Density
Control [AIDC] cycle).
The length of this
automatic cycle
depends on
environmental factors,
number of pages
printed, and whether
a new toner or OPC
drum has been
installed.
This process ensures
reliable printer
operation with
optimum output
quality. If you open
the door before the
display reads
MAGICOLOR
2350/IDLE
, the
printer stops and
repeats the calibration
cycle.
Your printer is not
connected to a
network.
The administrator has
set a password in
PageScope Light or at
the printer's control
panel.
Solution
Wait approximately 150 seconds
after rebooting your printer when
there has been an environmental
change such as in temperature or
humidity.
Wait approximately 170 seconds
after 200 1-sided pages of a
continuous print run.
Wait approximately 215 seconds
when the printer is "waking up" from
ENERGY SAVER and 1,000 or more
pages have been printed since the
last AIDC cycle.
Wait approximately 305 seconds
after the installation of a new toner
cartridge or OPC drum or if you start
an AIDC cycle manually using the
control panel or PageScope Light.
Make sure your printer is connected to
your workstation via TCP/IP and that
you are using a supported Internet
browser.
Either obtain the password from your
system administrator or use printer
driver and application print dialog boxes
to set your preferences.
Solving Other Problems