Console Diagnostics Tests; The Display Test; The Speaker Test - Stairmaster STEPMILL 7000 Owner's Manual

CONSOLE DIAGNOSTIC TESTS
The following tests must be performed while the console is in the DIAGNOSTIC
mode. To activate the DIAGNOSTIC mode, press [+ INCREASE], [1], [0], [7],
[ENTER]. The numbers will not appear on the display area as you enter them. If
the console fails any test, the console should be replaced or exchanged. To return
to the ATTRACT mode, press either [CLEAR] or [START/STOP] while in the
DIAGNOSTIC mode.

THE DISPLAY TEST

Use this test if the console display or text bar exhibits blank spots during use.
This test checks for inoperable Light Emitting Diodes (LEDs) in the console
display and the text bar. If any LED will not light, replace the console.
1. Press [0] to start the test.
2. All LEDs in the console display will flash on and off as a block.
3. Press [CLEAR] to end the test.

THE SPEAKER TEST

Use this test to make sure the console speaker is fully operational. The speaker
will ascend and then descend through the musical scale.
1. Press [1] to start the test.
2. Press [ENTER] to pause the test. Press [CLEAR] to end the test.
THE KEYPAD TEST
Perform this test if you are having trouble entering data into the console. If you
cannot enter the DIAGNOSTIC mode due to an inoperable keypad, replace the
console.
1. Press [2] to start the test.
2. The display LEDs will light up in an L-shaped formation, representing the
keypad matrix. Pressing a button on either the exercise program keypad or
Page 30