Table of Contents
Advertisement
GENERAL TROUBLESHOOTING GUIDELINES
This section outlines several tests to systematically identify and isolate the
cause of problems in the electrical system and the drive train. This troubleshoot-
ing section is organized into four basic problem sections: Electrical System,
Console Diagnostics, Speed Control, and the Drive Train. The first step is to
identify the problem. Once you have identified the problem, perform all the tests
in exactly the same order as written. Refer to the "Parts Removal
and Replacement" section of this Manual for all disassembly and assembly
instructions. To order a replacement part, or to get help with the troubleshooting
process, contact our Customer Service Department at (800) 331-3578.
International customers should contact their local distributor or call
(425) 823-1825.
TROUBLESHOOTING THE ELECTRICAL SYSTEM
The electrical system consists of: the power supply, main cable, relay board, load
resistor, and the console. In order to identify the component that is causing the
problem, you must systematically test the system. You will need a volt-ohm
meter (multimeter) to conduct portions of the following procedures. The console
and power supply are not serviceable by the owner. If either of these parts are
inoperable, they must be replaced. Opening the console or the power supply will
void the warranty.
The Console Fails to Power Up
A. Perform a visual check of the machine. Check the following things first:
1.
Is the power supply plugged in?
2.
Is the indicator light lit on the power supply? If it is, proceed to step
#3. If the light is not on, go to step B.
3.
Replace or exchange your console with a console you know is good
and retest the machine.
B. Verify AC power.
1. Disconnect the AC power cord from the AC wall outlet.
TROUBLESHOOTING
Page 27
Advertisement
Table of Contents
Troubleshooting
