Paradyne iMarc SLV Operation Manual page 90

3. Status and Statistics
Most Recent and Previous Cause Value Messages
The following Cause Value Messages are presented in alphabetical order. The
Cause Number is also provided if you need to convert the message to its
corresponding ITU number for your service provider.
Table 3-12. Most Recent and Previous Cause Value Messages (1 of 6)
3-54
Cause
Message No.
Bearer Capability 57
Not Authorized
Bearer Capability 65
not Implemented
Bearer Capability 58
Presently Not
Available
Call Awarded and 7
Being Delivered in
Est Chnl-7
Call Rejected 21
Call Terminated by 130
Remote End
Call With Requested 86
Call ID Has Been
Cleared
Channel Type Not 66
Implemented
Channel 6
Unacceptable
Destination Out of 27
Order
May 2003
What It Indicates
User has requested a
bearer capability that the
user is not authorized to
use.
Device sending this cause
does not support the bearer
capability (i.e., channel
type) requested.
Bearer capability requested
is supported by the device
generating the cause, but it
is not available at this time.
An incoming call is being
connected to an already
established channel that is
used for similar calls.
Equipment sending the
cause does not want to
receive the call at this time.
Remote DBM rejected or
terminated the call.
Network has received a call
resume request, but the call
had been cleared after it
was suspended.
Device sending this cause
does not support the
requested channel type.
Channel identified for the
call is not acceptable to the
receiving device.
Destination interface
specified is not functioning
correctly so the signalling
message could not be
delivered (e.g., physical or
data-link layer failure at the
remote end, user
equipment is offline).
What To Do
Arrange for the desired
capability.
Arrange for the desired
capability.
Arrange for the desired
capability.
No action is needed.
No action is needed.
1. Retry the call.
2. Verify that the remote
DBM's link profile is
correct.
No action is needed.
Arrange for the desired
capability.
Arrange for the desired
capability.
Verify that the remote
DBM's link profile is correct.
9000-A2-GB33-20