Paradyne iMarc SLV Operation Manual page 74

3. Status and Statistics
Table 3-6.
3-38
Health and Status Messages (7 of 7)
Message
SNR Margin Defect at Network 1
SNR Margin Threshold Exceed,
Network 1
Suboptimal Link Rate,
2
frame relay link
(ISDN DBM only)
Timeslot Discovery in Progress,
Network 1
Two Level-1 Users Accessing
Device
Test Call Active, ISDN Link Name
Yellow at DSX-1
Yellow at ISDN PRI (Active/Idle)
(ISDN PRI DBM only)
Yellow at Network 1
Yellow at T3 User, Port n
May 2003
What It Indicates
The observed SNR Margin is lower than the
configured threshold.
The observed SNR Margin has exceeded the
configured threshold.
The specified frame relay multilink has failed to
achieve the configured Maximum Link Rate for the
link.
This message appears for multilink aggregate frame
relay links if LMI is down on any of its constituent
links.
Time slot discovery is currently taking place to
determine the time slots that will be used for frame
relay traffic on the network interface.
This message only appears when the Time Slot
Discovery option is enabled (Main Menu→
Configuration→ Time Slot Assignment→Frame
Relay Network Assignments) and an LMI failure is
detected on the network interface's frame relay link.
Two Level 1 users are already using the menu-
driven user interface; only two sessions can be
active at one time.
A test call is active on the specified frame relay link,
the link being the ISDN Link Name assigned in the
ISDN Link Profile.
This message would only appear for models with the
built-in DBM.
A yellow alarm signal is received on the DSX-1
interface. DTE has detected a LOS or OOF
condition.
A yellow alarm signal is received on the ISDN
network interface.
Active – Backup call was in progress.
Idle – DBM was in Idle mode.
Indicates a possible cable problem.
A yellow alarm signal is received on the network
interface. Possible reasons include:
Network cable problem.
T1 facility problem.
A yellow alarm signal is received on the T3 user port
interface.
9000-A2-GB33-20