Paradyne iMarc SLV Operation Manual page 68

3. Status and Statistics
Health and Status Messages
The following table describes all possible Health and Status messages.
Table 3-6.
3-32
Health and Status Messages (1 of 7)
Message
AIS at DSX-1
AIS at ISDN PRI (Active/Idle)
(ISDN PRI DBM only)
AIS at Network 1
AIS at T3 User, Port n
Auto-Configuration Active
Back-to-Back Mode Active
Backup Active
Cable Mismatch, Port-n
COSnDownPathIP_Address,
interface[DLCInnnn]
Cross Pair Detection
Clock Out of Range at Network 1
May 2003
What It Indicates
An Alarm Indication Signal (AIS) is received by the
DSX-1 interface. AIS is an unframed, all ones signal.
An Alarm Indication Signal (AIS) is received by the
ISDN PRI interface. AIS is an unframed, all ones
signal.
Only appears when a PRI dial backup module (DBM)
is installed.
Active – Backup call was in progress.
Idle – DBM was in Idle mode.
The ISDN network is transmitting an AIS.
An Alarm Indication Signal (AIS) is received by the
network interface. AIS is an unframed, all ones
signal. Possible reasons include:
Upstream iMarc unit is transmitting AIS
(keep-alive signal).
The network is transmitting an AIS.
An Alarm Indication Signal (AIS) is being received on
the T3 user port interface.
Auto-Configuration feature is active, which allows
automatic configuration and cross-connection of
DLCIs as they are reported by the network LMI.
The operating mode has been configured for
back-to-back operation (Main Menu→ Control →
Change Operating Mode).
The iMarc unit can be connected to another iMarc
unit without a frame relay switch between them.
This feature is useful for product demonstrations or
for a point-to-point configuration using a leased line.
Backup has been established and data is flowing
over the alternate DLCI.
The presence or absence of an adapter cable on
Port n is inconsistent with the Port Type setting.
The class of service associated with the path is
unavailable.
The TX pair and RX pair are reversed on the DDS
network interface. DLCI is not displayed if service
type is PPP.
The clock rate detected on the network interface is
not within the range supported by the device.
9000-A2-GB33-20