Paradyne iMarc SLV Operation Manual page 70

3. Status and Statistics
Table 3-6.
3-34
Health and Status Messages (3 of 7)
Message
Excessive BPVs at Network 1
Fan Failure
Internal Modem Failed
ISDN Active
ISDN Link Profile Disabled
ISDN Link Name
ISDN Link Profile Invalid,
ISDN Link Name
ISDN Network Failed (Active/Idle) An ISDN network failure was detected when:
LatencyIP_ Address,
COSx,interface[DLCInnnn]
Lease Line Active
Link Layer Down, interface
Link Down Administratively, link
Link Profile Disabled,
ISDN Link Name
LLB Active, [Interface]
LMI Discovery in Progress, frame
relay link
LMI Down, frame relay link
LOF at Network 1
May 2003
What It Indicates
An Excessive Bipolar Violations condition is detected
on the DDS network interface.
At least one of the system fans has failed.
The unit's internal modem failed to pass the self-test.
An ISDN call is active.
An ISDN backup call could not be made because the
ISDN link profile specified Link Name is disabled
(Main Menu→ Configuration→ ISDN→
Link Profiles).
No phone numbers have been specified in the ISDN
link profile (specified by ISDN Link Name).
Active – Backup call was in progress.
Idle – DBM was in Idle mode.
An IP SLV Latency Threshold has been exceeded for
the specified COS of the path. IP_Address is the IP
address of the path endpoint, COSx is the Class of
Service ID associated with the path, and nnnn is the
DLCI which contains the path. DLCI is not displayed
if service type is PPP.
The service type is Leased Line.
The link layer is down on the specified interface.
The specified frame relay or PPP link has been
disabled by the unit due to a dependent relationship
in the device configuration, such as LMI behavior
conditions or a PPP link going down.
An ISDN backup call could not be made because the
specified link profile was disabled.
A network Line Loopback (LLB) is active on the
specified interface.
Local Management Interface protocol discovery is in
progress to determine which protocol will be used on
the specified frame relay link.
The Local Management Interface(s) has been
declared down for the specified frame relay link.
For an individual ISDN link, the message appears
when LMI has been declared down on the link.
For a multilink aggregate link, the message
appears when LMI has been declared down on all
constituent links of the frame relay multilink.
A Loss Of Frame condition has occurred on the T3
network interface.
9000-A2-GB33-20