Paradyne iMarc SLV Operation Manual page 195

Table 5-5.
When the ping has completed normally, timed out, or been stopped using the Stop
command, informational fields are displayed as shown in
Responses.
Table 5-6.
9000-A2-GB33-20
Ping Options (3 of 3)
Iteration Count
Available Settings: 1–999999
Default Setting: 5
Specifies the number of pings to send.
1–999999 – Number of pings.
Inter-Ping Delay
Available Settings: 1–900
Default Setting: 1
Specifies, in seconds, the amount of time to wait between pings.
1–900 – The ping wait time.
Response Timeout
Available Settings: 1–60
Default Setting: 2
Specifies the amount of time, in seconds, to wait before a host that has not responded to a
ping is declared unreachable.
1–60 – The response timeout period.
Ping Responses (1 of 2)
Field Possible Values
Status
Ping Loss Ratio (%) 0–100
Pings Transmitted 1–999999
Pings Received 1–999999
Pings Lost 1–999999
May 2003
Description
In Progress Ping has been sent.
Alive Ping was successful.
Destination The host could not be reached. See
Unreachable RFC 792 for possible causes.
Ping Timed Out There was no response in the period
specified in Response Timeout.
No route in this The IP address is not in the routing
device table, and no Default IP Destination is
configured.
The ratio of pings received to pings
transmitted.
The number of pings transmitted.
The number of pings received.
The number of pings transmitted less the
number of pings received.
5. Troubleshooting
Table 5-6, Ping
5-51