Paradyne iMarc SLV Operation Manual page 23

Procedure
To limit asynchronous terminal access to the menu-driven user interface:
If connecting an asynchronous terminal to the unit's:
„
„
9000-A2-GB33-20
1. Select the appropriate port options.
Main Menu→Configuration→Management and Communication→
Communication Port
Main Menu→Configuration→Management and Communication→
Modem Port
2. Set the following configuration options, as appropriate.
To . . .
Require a login
Limit the effective access level
to Level-3 or Level-2
NOTE:
See Resetting the Unit and Restoring Communication
Troubleshooting, should you be locked out inadvertently.
3. Save your changes.
COM port – See the iMarc SLV Configuration Reference
about the communication (COM) port.
Modem port – See Setting Up Call Directories for Trap Dial-Out and
Configuring the Modem Port in
additional information.
May 2003
Set the configuration option . . .
Login Required to Enable.
NOTE: User ID and password combinations must
be defined. See Creating a Login
Port Access Level to Level-2 or Level-3.
NOTE: Regardless of a user's login access level, a
user cannot operate at a level higher than the
access level specified for the port (e.g., if a user has
a Level-1 login and Level-2 port access has been
set, the Level-1 user can only operate as a Level-2
user).
If you are going to allow Level-1 users to configure
the unit, keep the access at Level-1.
iMarc SLV Configuration Reference
2. Security and Logins
on page 2-12.
in Chapter 5,
for more information
for
2-3