Paradyne iMarc SLV Operation Manual page 58

3. Status and Statistics
Table 3-3.
3-22
Display LEDs and Control Leads Screen Labels (3 of 4)
Label Indication
Network1, continued
Models 9783 and 9788 CSU/DSUs and Routers:
Data Mode Data Mode
Active
LOS Loss Of Signal
Training Training in
Progress
LCD Loss of Cell
Delineation
Model 9820-45M:
DTR Data Terminal
Ready
DSR Data Set Ready
Models 9123, 9126, 9128:
SIG T1 Signal
OOF Out of Frame
ALM Alarm
Port-n
Models 9123, 9126, 9128, 9623, 9626, 9720, 9783, 9788:
OK Operational
Status
May 2003
What It Means
ON – The unit has trained up and is operating in normal
data mode. The front panel DSL LED is on.
OFF – The unit has not trained up.
ON – An LOS condition has been detected on the
network. The front panel ALM LED is on.
OFF – No LOS condition is detected.
ON – The unit is training and the DSL LED is flashing.
OFF – The unit is not training.
ON – An LCD alarm condition has been detected. On
the 9783, the front panel ATM LED is yellow.
OFF – No LCD condition is detected.
ON – The DTR lead is asserted.
OFF – The DTR lead is not asserted.
ON – The DSR lead is asserted.
OFF – The DSR lead is not asserted.
ON – A recoverable signal is present on the
Network/DSX/PRI interface.
OFF – The signal cannot be recovered from the
Network/DSX/PRI interface. An LOS condition exists.
ON – At least one OOF was detected during the
sampling period.
OFF – No OOFs were detected during the sampling
period.
ON – An alarm condition is present on the
network/DSX/PRI interface.
OFF – No alarm condition is present on the
Network/DSX/PRI interface.
ON – The interchange circuits for the port are in the
correct state to transmit and receive data.
OFF – The port is idle. Occurs if the port is disabled, or
if the port is configured to monitor DTR and/or RTS and
the lead(s) is not asserted.
9000-A2-GB33-20