Starting And Stopping A Test - Paradyne iMarc SLV Operation Manual

Starting and Stopping a Test

Use this procedure to start, monitor, or abort specific tests. To abort all active tests
on all interfaces, see
Start or stop an individual test using the same procedure.
Procedure
To start and stop a loopback or a send-pattern test:
9000-A2-GB33-20
Aborting All Tests
When the status of a test is . . .
Inactive
Active
1. Follow this menu selection sequence:
Main Menu→Test
2. Select an interface and test (e.g., Network, Data Port, or ISDN PVC Tests) and
press Enter.
The selected test screen appears. Start appears in the Command column.
Inactive appears in the Status column.
3. Select the Port number and press Enter.
4. Select the DLCI number and press Enter if a PVC test has been selected.
The cursor is positioned at Start in the Command column of the first available
test and is highlighted.
5. To start the test, highlight Start under Command for the test you want to run
and press Enter. Stop now appears and is highlighted, and the status of the
test changes to Active.
The length of time that the test has been running is shown in the Result
column.
6. To stop the test, press Enter to send the Stop command. Start reappears
and the status of the test changes back to Inactive.
May 2003
on page 5-22.
The only command available is . . .
Start
Stop
5. Troubleshooting
5-21