Paradyne iMarc SLV Operation Manual page 64

3. Status and Statistics
Table 3-4.
3-28
Device Messages (5 of 6)
Message What It Indicates
Permission Denied A file transfer was
attempted, but the:
(Seen at an FTP
terminal.)
Please Wait Command takes longer
than 5 seconds.
Port Inactive The port is disabled, or it
supports synchronous data
(iMarc SLV 9128-II
when a DTE Loopback was
only)
started.
Resetting Device, Yes (or y) was entered in
Please Wait ... the Reset COM Port usage
field of the System Paused
menu.
Save Cancelled Changes were made on the
Easy Install screen, but
(iMarc SLV 9128-II
when it came to saving the
only)
changes, the Esc key was
pressed or No was entered
in response to the Save
Changes? prompt.
Test Active No higher priority System
and Test Status messages
exist, and a test is running.
May 2003
What To Do
User did not have Level
1 security.
Wrong file was specified
when the put command
was entered.
User attempted to
upload a program file
from the unit.
Wait until message clears.
No action is needed.
No action needed.
No action is needed.
See your system administrator
to get your security level
changed.
Try again, entering the correct
file with the put command.
Enter the put command
instead of a get command; you
can only transfer files to the
unit, not from it.
See Upgrading System
Software in Chapter 4,
Operation and Maintenance.
Contact service provider if test
initiated by the network.
Wait until the test ends and
message clears.
Cancel all tests from the Test
screen (Path: main/test).
Stop the test from the same
screen the test was started
from.
9000-A2-GB33-20