5. Troubleshooting
Aborting All Tests
Use the Abort All Tests selection from the Test menu to abort all tests running on
all interfaces, with exception to DTE-initiated loopbacks. To abort individual tests
that are active, see
Procedure
To abort all tests on all interfaces:
5-22
Starting and Stopping a Test
1. Follow this menu selection sequence:
Main Menu→Test
2. Select Abort All Tests and press Enter.
Command Complete appears when all tests on all interfaces have been
stopped.
NOTE:
Abort All Tests does not interrupt DTE-initiated loopbacks.
May 2003
on page 5-21.
9000-A2-GB33-20