Changing Access Levels
The Operator and Administrator have the same Login ID with different passwords
for their access level. To determine the level of access for a session, refer to
Access Levels (Command Modes)
After accessing the router's CLI:
For further details, refer to the
Router Command Line
9000-A2-GB33-20
You can access the Administrator access level by entering:
enable
The router's defaults to no password required. To require a password to
access the Administrator access level, enter:
enable password password
Once saved, the router responds with a prompt to enter a password for
Administrator access. This command is in effect until no enable password
[ password ] is entered and saved.
You can end the current Administrator access level by entering:
exit
This command results in ending the current Administrator access level
session. Exit may need to be entered several times to reach Operator level
and/or end the session.
You can end the Administrator access level by entering:
end
This command results in ending the Administrator access level session and
returning immediately to Operator level.
Interface.
May 2003
on page 2-14.
iMarc SLV Configuration Reference
2. Security and Logins
and
iMarc SLV
2-15