Upgrading Isdn Bri Dbm Software - Paradyne iMarc SLV Operation Manual

4. Operation and Maintenance

Upgrading ISDN BRI DBM Software

A separate download to update PRI DBM functionality is not necessary; a PRI
upgrade is incorporated in the unit's program code. However, if the iMarc unit has
a BRI DBM, the program code must be upgraded separately.
To upgrade an iMarc unit's BRI DBM program code, you must transfer the
dbmprog.ocd file in the Dial Backup Module directory using the put command.
Procedure
To perform a BRI DBM upgrade:
4-10
1. Initiate an FTP session to the device that you are upgrading.
2. Type bin to enter binary transfer mode.
3. Type cd dbm to change to the Dial Backup Module directory.
NOTE:
If the iMarc unit is not equipped with a DBM or the DBM does not contain
any downloadable software, the message dbm: no such file or
directory appears.
4. Perform a put of Rxxxxxx.ocd (xxxxxx being the software release number) to
the dbmprog.ocd file to start the upgrade.
If the message displayed is . . .
DBM Download Required
dbmprog.ocd: File Transfer Complete The download was successful.
dbmprog.ocd: File Transfer Failed
5. Close the FTP session.
6. Verify that the new software release was successfully installed as the DBM
Software Revision.
Main Menu→Status→Identity
May 2003
Then . . .
Errors were detected during the DBM
download.
The dbmprog.ocd file will need to be
downloaded again.
The download was not successful.
Possible cause: A bad or invalid file, or the
wrong checksum.
A different dbmprog.ocd file will need to be
downloaded for the DBM to become
operational. Repeat the step or end the FTP
session.
9000-A2-GB33-20