Paradyne iMarc SLV Operation Manual page 194

Imarc slv
Table of Contents

Advertisement

5. Troubleshooting
Table 5-5.
5-50
Ping Options (2 of 3)
Source IP Address
Available Settings: Automatic, Special
Default Setting: Automatic
Specifies the source IP address to be identified with the ping.
Display Conditions – This setting does not appear when Destination Interface is set to
Use_Internal_Route.
Automatic – The source IP address is:
– The interface IP address, if one exists, else
– The node IP address if one exists, else
– The first available address in the address table
Special – The entered IP address is shown as the source. When Special is specified, and
additional field is displayed that allows you to enter an IP address
000.000.000.001–126.255.255.255, or 128.000.000.000–223.255.255.255.
Encapsulation
Available Settings: Routed
Default Setting: Routed
Specifies the IP encapsulation used by the data stream. This read-only field specifies that
the IP encapsulation used is RFC 1490/RFC 2427 routed Network Level Protocol
IDentifier (NLPID) encapsulation, and not SubNetwork Attachment Point (SNAP)
encapsulation.
Display Conditions – This setting does not appear when Destination Interface is set to
Use_Internal_Route.
Routed – The encapsulation is routed NLPID.
TOS Byte
Available Settings: A predefined COS ID, or a user-defined binary value 0000–1111
Default Setting: User Defined – 000000
(Release 2.1.) Specifies the TOS (Terms Of Service) byte to be used with the ping packet.
Select from COS (Class Of Service) definitions, if any exist, or specify a binary value.
When a COS definition is selected, the TOS byte value is read-only. If you select a COS
definition that has multiple COS IDs, the lowest value is used as the TOS byte. See
Configuring Class of Service Definitions in the
0000–1111 – The value of the TOS byte.
Packet Size
Available Settings: 36–4096
Default Setting: 100
Specifies the size of the ping packet including the IP header (20 bytes) and the ICMP
header (8 bytes).
1–4096 – Packet size.
May 2003
iMarc SLV Configuration
Reference.
9000-A2-GB33-20

Advertisement

Table of Contents
loading

Table of Contents