FujiFilm Drypix 5000 Operation Manual page 66

Utility Operation
5 The display then changes to a screen like that shown below, where you can set up a
time period for Economy Mode and None Economy by the day of the week.
[Fig. 4.42] Scheduler Screen
If the operation panel is not touched or no data comes from the outside exceeding the time
period specified so that the Transition Time is effective, the Economy Mode function will be
performed.
(1) Press the ECONOMY MODE or NON ECONOMY button to select a mode you
want to set.
(2) Use the
MODE or NON ECONOMY and press the
for ECONOMY MODE and white for NON ECONOMY.
(3) Use the
MODE or NON ECONOMY and press the
You are then returned to [Fig. 4.42].
[Fig. 4.43]
(4) Repeat steps (1) through (3) for each day of the week to perform necessary settings.
(5) Check to see that settings have been performed correctly and press the
button to determine the setup data.
(6) Press then the
Note that the setup data is determined only when you press
has been pressed accordingly.
(7) To perform settings for "Calendar" consecutively, press the
[Fig. 4.41] and proceed to "4.8.3 Calendar". If you do not wish to perform settings
for "Scheduler" and "Time of Office Closed", press the
[Fig. 4.41] and then the same button on [Fig. 4.40]. You can then exit Economy
Mode to return to the Utility Initial screen.
4-26
buttons to select a position for starting time of ECONOMY
buttons to select a position for finish time of ECONOMY
button to return to the [Fig. 4.41] Details screen.
button. The cell then turns red
button.
after
button on
button on
006-240-20 2004.03