FujiFilm Drypix 5000 Operation Manual page 31

Basic Operation
5 Place a new film pack in the empty tray following the procedure below.
5-1 Remove the film pack from the carton.
5-2 With the film pack arrow mark pointing upward, set it in place so that the
the label of the film pack is aligned with the
[Fig. 3.15]
5-3 Break the label while lifting the end of the film pack slightly, and then open both
sides of the film pack as shown below.
[Fig. 3.16]
5-4 Using the cutter placed on the right-hand side of the operation panel, cut the film
pack along with the tray edge as illustrated below.
[Fig. 3.17]
If the cutter's blade protection is broken, the blade will be exposed posing then
CAUTION
danger to the user. Do not touch the unprotected blade.
Replace a dull cutter hard to cut the film pack, as necessary.
006-240-40 2006.09
Cutter
mark on the tray as illustrated below.
Use the DI-HL, DI-HLc, or
DI-ML film. (The arrow mark is
printed on the red background.
For the DI-ML film, it is printed
on the green background.)
Images cannot be recorded
correctly if films such as
DI-AL, etc. are used.
1
mark on
2
3
4
5
6
7
3-9