FujiFilm Drypix 5000 Operation Manual page 33

Basic Operation
5-8 The display returns to the routine screen. This completes the film supply
procedure. Note, however, that if you have selected By each film pack for
AUTOMATED F.D.C. in the Utility mode, the Auto F.D.C. (automatic film density
calibration) will be performed. After completion of the density calibration
procedure, the display returns to the routine screen.
For details of AUTOMATED F.D.C., see Chapter 4, Utility Operation.
6 When an incorrect film pack was loaded or films of unspecified type were loaded
6-1 When an incorrect film pack was loaded:
When the film pack is loaded incorrectly (loaded up-side-down, one end of the film pack is
not outside the tray), the related tray will be unlocked. Then, the following screen will
appear.
If you want to stop loading films while the following screen [Fig. 3.21] is being
displayed on the operation panel, remove the film pack and close the tray.
Press the
[Fig. 3.21]
006-240-30 2006.05
button will appear on the operation panel.
button, and open and then close the tray again.
1
2
3
4
5
6
7
3-11