FujiFilm Drypix 5000 Operation Manual page 45

Utility Operation
4 At the press of the
Selecting the
maximum density (Dmax) value. You can use this function when you wish to change the maximum
density with respect to the setup value, depending on the view box luminance or room brightness.
To perform automatic film density calibration by selecting a shift value for high-density calibration
(Dmax), select a desired tray on the [Fig. 4.6] Tray Select Screen and then
press
[Fig. 4.7] Shift Value (Dmax) Select Screen
The range of variation of the density shift value by automatic film density calibration is presented
to be served as a guideline.
The specification of this equipment provides that the maximum density is 3.6 and a density that
exceeds 3.6 will not be guaranteed.
Note, however, that the maximum density specified for the DI-ML film is 4.0.
006-240-40 2006.09
button, the automatic film density calibration will be performed.
icon on [Fig. 4.6] Tray Select Screen will enable you to finely adjust a
.
3.6
2.5
REFERENCE
If the shift value (Dmax) is changed, densities over
OD=2.5 will change.
Changing the shift value by 1 step will change the
density by about 0.1 at OD=3.6.
At the press of the
shift value for high-density calibration (Dmax)
selected accordingly, the shift value applicable to
automatic film density calibration will be deter-
mined.
If the button is pressed, the display
will return to the [Fig. 4.6] Tray Select Screen.
If the button is pressed on the
[Fig. 4.6] Tray Select Screen, automatic film
density calibration processing will be performed.
Shift value=2
Shift value=1
Shift value=0
Shift value=–1
Shift value=–2
Image input value
button here with a
1
2
3
4
5
6
7
4-5