FujiFilm Drypix 5000 Operation Manual page 115

Troubleshooting
1 Input a 20-digit barcode of the label affixed on the back of the bag that contains films,
and press the
[Fig. 5.33]
2 If the barcode thus input has been recognized correctly, the display changes to that
shown below. Press the
[Fig. 5.34]
3 If the input barcode is not recognized properly, the [Fig. 5.30] window appears again.
Reinput then the same barcode. If the barcode cannot be recognized successfully even
after it has been input three times, the display changes to the following. Press the
[Fig. 5.35]
006-240-20 2004.03
button.
Input this 20-digit figure.
button to return to the routine window.
button. The display returns to the routine window.
4924863579513604891
In this case, the AUTOMATED F.D.C.
function will not be activated.
A slight difference may result in the
density due to differences in sensitiv-
ity among film lots. Correct the
density following the automated
density calibration process de-
scribed in 4.3.
1
2
3
4
5
6
7
5-29