Supplying Film (Replacing The Film Pack) - FujiFilm Drypix 5000 Operation Manual

Basic Operation

3.2 Supplying Film (Replacing the Film Pack)

When the film in the supply tray runs out, the screen background turns yellow and the
button appears. Pressing this button will display the
An attempt to output films in this status will sound the film supply alarm.
* The alarm will not sound if it has been set to OFF.
When the equipment is operated with the two film trays loaded with films of the same size
of the same type, if the film in Tray 1 runs out, the supply tray will automatically switch over
to Tray 2.
In this case, the alarm will not sound until the film in Tray 2 runs out and film output contin-
ues even thought the
When the equipment is operated with all the three trays loaded with films of the same size
of the same type, the alarm will not sound until the third tray becomes completely empty
continuing thus film output.
Follow the procedure below to replace the film pack with new one.
See the animation that appears in the display. This animation will facilitate you to know how
to replace the film pack. If you wish to see it again, press the
Note that if the
displayed.
Use only DI-HL, DI-HLc, or DI-ML films for Fuji Medical Dry Laser Imager.
CAUTION
Images cannot be recorded correctly if other films are used.
1 Press the
[Fig. 3.11]
2 Press the
[Fig. 3.12]
006-240-40 2006.09
button is displayed.
button is pressed, the procedure to be performed the next will be
button to stop it.
button to unlock it.
button.
button.
1
2
3
4
5
6
7
3-7