Maintenance And Inspection - FujiFilm Drypix 5000 Operation Manual

Maintenance and Inspection

During maintenance and inspection, strictly observe precautions contained in "1.3 Safety" (page 1-3) and "1.4
Operational Precautions" (page 1-4) in this manual for you to use the DRYPIX 5000 system under best condi-
tions.
1 User's Maintenance and Inspection Items
1.1 Daily Inspection
(1) Inspection Before Use
•
Make sure that the equipment starts up normally.
•
Make sure that the equipment communicates with connected devices via the cables normally.
➡ "Step 1 Starting Up the System" (page 3-3)
(2) Inspection During Use
•
Make sure that the equipment outputs films normally.
➡ "Step 3 Printing Images (film output)" (page 3-5)
•
Make sure that images are output normally.
If the film manufacture No. has been changed or any anomalies appear on image, see Chapter 6.
➡ Chapter 6 Regular Care and Maintenance (page 6-1)
(3) Inspection After Use
•
Make sure that the power turns OFF normally after the equipment has been shut down.
➡ "Step 4 Shutting Down the System" (page 3-6)
1.2 Periodical Inspection
Using a vacuum cleaner, remove any dirt or dust accumulated in each unit of the equipment once every three
months. Clean then with a slightly moistened soft cloth and wipe off any moisture with a dry cloth.
➡ Figure 2.2 in "2.2 Hardware Configuration" (page 2-3) and Chapter 6 Regular Care and Maintenance
(page 6-1)
No. Unit for Cleaning
1 Main unit front cover
2 Main unit operation panel
3 Inside of the trays
4 Equipment periphery
5 Suction filter (on the left side)
6 Cleaning roller (washing with water)
7 Filter inside the front cover
2 Maintenance and Inspection Items Assigned to Specified Dealer
For periodical inspection of the equipment and necessary arrangements, consult our official dealer or local
representative.
006-240-40 2006.09