Failing In Reading A Barcode - FujiFilm Drypix 5000 Operation Manual

Troubleshooting

5.4 Failing in Reading a Barcode

When a film pack is replaced, this equipment reads a barcode affixed on the
film pack and manages the film lot number and other information.
[Fig. 5.29]
Arrow mark label
The oblique line
portion has been
removed.
If, for any reason, the equipment fails in reading the barcode, an error window like that
shown below appears.
[Fig. 5.30]
Press the
placed correctly in the tray.
1 Does the label have red or green (DI-ML) arrow mark? Films other than with red or green
mark cannot be used. Replace with a correct film pack, and complete film replenish-
ment.
2 Is the film pack placed in the right position? (Fig. 5.29)
3 Is the film pack placed evenly?
If the film is not placed properly, replace it in a correct way, and push back the tray in.
If the same error recurs even though the film pack has been placed correctly, you can
forcibly continue the operation after it was removed.
006-240-40 2006.09
Barcode
button to pull out the tray. Reconfirm then whether film pack is
back
Film pack
1
of the
2
3
4
5
6
7
5-27