Connect Devices; Input Video Mapping; Four-Port: 3Gic, Tdpic, Thic Cards - Christie Mirage 4K25 Setup Manual

Connect Devices

This section provides information and procedures for connecting external devices to the projector.
Communication and input ports are located on the projector side input panel, accessed by removing
the input panel cover. When connecting devices, you can route cables through the opening in the
frame to the side input panel or directly to the video option cards and MCPU. The image below
shows the video option card slot numbers and the MCPU panel.
Input signal devices are connected to the video option cards and the option card slot numbers are
important for some types of input signals. Communication devices are connected at the MCPU
panel.

Input video mapping

Video input mapping depends on the type of cards used for the Four-Port or Two-port input
configurations.

Four-Port: 3GIC, TDPIC, THIC cards

The following table shows the video quadrant mappings for the 3GIC, TDPIC, and THIC Four-Port
input configurations:
Four-Port Input Configuration—Two Cards (1)
Slot 1
Slot 1
Mirage 4K25 Setup Guide
020-101362-02 Rev. 1 (01-2015)
1-In
2-In
Quadrants Columns
Top left 1 (left most)
Bottom left 2
25